Table of Contents
Advertisement
Daylight Sensor Setup
Zone Mode
This step allows you to assign sensors to zones on the GRAFIK Eye QS control unit.
Each zone can be assigned to only one sensor, but sensors can be assigned to more
than one zone.
Assigning Sensors
Daylight Sensor
1. If not already done, associate daylight sensors and set to
Setup
"Zone Mode".
2. Use the Master buttons to highlight "Setup" and press the
Calibrate
"OK" button to accept. Available sensors will be displayed.
3. Use the Master buttons to scroll through the sensors until the
one you wish to assign or unassign is highlighted, and press
the "OK" button to select it.
Saved
Searching
4. Use the zone raise and lower buttons for the desired zones to
assign or unassign the sensor to those zones. The zone raise
button assigns the displayed sensor, and the zone lower button
unassigns it. Press the Timeclock (back) button to return to the
Sensor
x/y
list of available sensors. Repeat for additional sensors.
xxxx-xxxx:
Calibrating the Sensors
1. Put any wireless Radio Powr Savr daylight sensors associated
RF
with the desired zones into "Calibrate Mode": Press and hold
the "Cal" button for 6 seconds until the sensor flashes.
Note: After 5 minutes, "Calibrate Mode" will timeout, and the
Sensor
2. Press the Timeclock (back) button to return to the Daylight
Set Zones
Sensor screen. Use the Master buttons to highlight "Calibrate"
and press the "OK" button to accept.
3. Use the Master buttons to select the desired zone and press
the "OK" button to accept.
4. Use the Master buttons to select the desired light level for the
zone, and press the "OK" button to accept. Repeat for all zone
levels you wish to calibrate.
5. Exit programming mode.
Note: If wireless sensors are not found, verify that they are
Daylight Sensor
Setup
3 seconds
Calibrate
®
(continued)
1
9
sensor will return to normal mode.
associated correctly.
Sensor Name
Adjust Light
More light
Zone 1
Less light
GRAFIK Eye QS with EcoSystem Control Unit Installation and Operation Guide 41
2
10
3
11
4
12
5
13
6
14
Saved
Saved
7
15
8
16
9-16
1-8
OK
1
9
2
10
3
11
1
9
2
10
3
11
Radio Powr Savr
Daylight Sensor
Master
buttons
"OK"
button
Timeclock
(back) button
4
12
5
13
6
14
7
15
8
16
4
12
5
13
6
14
Zone raise: Press to
assign the displayed
sensor
Zone lower: Press to
unassign the desired
sensor
"Cal"
button
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the GRAFIK Eye QS with EcoSystem and is the answer not in the manual?