Master/Slave; Dmx-512; Network Settings; Signal Source - SHOWTEC LED Octostrip Set MKII V1 Manual

LED Octostrip Set MKII
08) Press the SETUP button to enter and to toggle between the 2 options below. Once you have chosen
the desired option, do as follows:
09) Once you have adjusted the settings, press the SETUP button to confirm.

3. Master/Slave

With this menu you can set the device as a master or a slave device.
01) Press the MODE button until the display shows
02) The device is now operating in slave mode and will react the same as the master device.

4. DMX-512

With this menu you can set the device's DMX starting address and the desired DMX channel mode.
01) Press the MODE button until the display shows
02) Press the SETUP button to open the menu.
03) Press the UP/DOWN buttons to set the desired DMX starting address. The adjustment range is
between
04) Press the SETUP button again to proceed to channel mode settings.
05) Press the UP/DOWN buttons to choose one of the 7 DMX channel modes: 6CH, 8CH, 14CH, 26CH,
50CH, 192CH or 208CH.
06) Press the SETUP button to confirm.

5. Network Settings

With this menu, you can adjust the device's properties, such as the IP address, subnet mask and the
universes.
01) Press the MODE button until the display shows
02) Press the SETUP button to open the menu.
03) Press the UP/DOWN buttons to toggle between the 6 options below.

5.1. Signal source

With this menu you can select thed esired signal source: DMX or ArtNet.
01) Press the UP/DOWN buttons until the display shows
02) Press the SETUP button to open the menu.
03) Press the UP/DOWN buttons to choose between DMX or ArtNet.
04) Press the SETUP button to confirm.
05) If you have chosen ArtNet, press the MODE button until the display shows
be received properly. Otherwise, the device will not function in ArtNet mode.

5.2. IP address

With this menu you can set the IP address.
01) Press the UP/DOWN buttons until the display shows
02) Press the SETUP button to open the menu. The display will show
03) Repeatedly press the SETUP button to skip to the desired section of the IP address (the currently
selected section will blink).
04) Press the UP/DOWN buttons to set the values.
05) Press the SETUP button to confirm.
Ordercode: 42232
Program speed (Press the UP/DOWN buttons to increase/decrease program
speed. The adjustment range is between 1-100, from slow to fast.)
Strobe (Press the UP/DOWN buttons to set strobe frequency. The adjustment
range is between 0-99, from OFF to high frequency.)
.
19
.
.
.
.
.
.
, for the signal to