Table of Contents
Advertisement
LED Octostrip Set MKII
Maintenance
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
01) All screws used for installing the device or parts of the device have to be tightly connected and
must not be corroded.
02) There may not be any deformations on housings, fixations and installation spots.
03) Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
04) The electric power supply cables must not show any damages or material fatigue.
The LED Octostrip Set MKII requires almost no maintenance. However, you should keep the unit clean.
Otherwise, the fixture's light output will be significantly reduced. Disconnect the mains power supply, and
then wipe the cover with a damp cloth. Do not immerse in liquid. Do not use alcohol or solvents.
Please clean internal components once a year with a light brush and vacuum cleaner.
Keep connections clean. Disconnect electric power, and then wipe the DMX connections with a damp
cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric power.
Replacing the Fuse
Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the
fuse burns out, the product will not function whatsoever. If this happens,
so.
01)
Unplug the unit from electric power
02)
Insert a screwdriver into the slot in the fuse cover.
come
out.
03)
Remove the used fuse. If brown or unclear, it is burned
04)
Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse holder. Be sure
to
use a fuse of the same type and specification. See the product specification label for details.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
No Light
If the light effect does not operate properly, refer servicing to a technician.
Suspect three potential problem areas as: the power supply, the fuse and the LEDs.
01) Power supply. Check that the unit is plugged into an appropriate power supply.
02) The fuse. Replace the fuse. See page 45 for replacing the fuse.
03) The LEDs. Return the LED Octostrip Set MKII to your Showtec dealer.
04) If all of the above appears to be O.K., plug the unit in again.
05) If you are unable to determine the cause of the problem, do not open the Controller, as this may
damage the unit and the warranty will become void.
06) Return the device to your Showtec dealer.
Ordercode: 42232
source.
Turn the fuse holder counterclockwise.
out.
45
follow the directions below to do
The fuse will
Advertisement
Table of Contents
