Multiple Octostrips (Artnet Control) - SHOWTEC LED Octostrip Set MKII V1 Manual

LED Octostrip Set MKII

Multiple Octostrips (ArtNet Control)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a CAT-5/CAT-6 cable to connect the Octostrips and other ArtNet devices.
04) Link the units as shown in fig. 06. Connect the first Octostrip's RJ45 "out" socket with the second unit's
"in" socket, using a CAT-5/CAT-6 signal cable. Repeat this process to link the second, third, and
fourth units.
05) Using a CAT-5/CAT-6 cable, connect the first Octostrip's RJ45 "in" socket to the PC (Windows or Mac)
with installed ArtNet software.
06) Supply electric power: Plug electric mains power cords into each unit's Pro power socket, then plug
the other end of the mains power cord into proper electric power supply sockets, starting with the
first unit. Do not supply power before the whole system is set up and connected properly.
Multiple Octostrips ArtNet Set Up
Ordercode: 42232
Note : Link all cables before connecting electric power
12
Fig. 06