Multiple Octostrips (Dmx Control) - SHOWTEC LED Octostrip Set MKII V1 Manual

LED Octostrip Set MKII

Multiple Octostrips (DMX Control)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the Octostrips and other devices.
04) Link the units as shown in fig. 05. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX signal cable. Repeat this process to link the second, third, and fourth units.
05) Connect a light controller to the first device's "in" socket, using a DMX cable.
06) Connect the included 8 LED strips to the Octostrip's 5-pin XLR "out" sockets.
07) Supply electric power: Plug electric mains power cords into each unit's Pro power socket, then plug
the other end of the mains power cord into proper electric power supply sockets, starting with the
first unit. Do not supply power before the whole system is set up and connected properly.
Multiple Octostrips DMX Set Up
Ordercode: 42232
Note : Link all cables before connecting electric power
11
Fig. 05