Table of Contents
Advertisement
OPERATION - 2084
Edge Slitters
Wedger
Center Paper Guide
8-Pin Tractor, OP
Fig. 22b
Form Set-up Procedure
1. Turn on the machine. Measure form length.
2. Press the form length switch on the burster to align
the alignment mark with the form length on form length
scale. (Fig. 23)
Form Length Scale
Fig. 23
3. Place form stack on pull down tray on right side of
the burster.
Slitter Adjustment
Alignment Mark
Screw
8-Pin Tractor, Dr
Alignment Mark
4. Center leading edge of form at infeed end of the
burster.
5. Position tractors to proper form width by releasing
thumbscrews on top of tractors and sliding tractors to
proper width. Raise tractor gates.
6. Lay margin holes of form over feed pins. (Fig. 24)
NOTE: Do not stretch form too tightly between
pins; pins should be centered in margin holes.
Fig. 24
7. Close tractor gates and lock tractors by tightening
thumbscrews.
8. If using edge slitters, position alignment mark where
you wish to slit. (Fig. 22b)
9. If slitting, be sure that slitter blades are engaged.
This is accomplished by rotating wedger in a
counterclockwise direction as far as they will go without
force. (Fig. 22b)
10. Lock edge slitters in place by tightening
thumbscrews clockwise. (Fig. 22b)
NOTE: If you do not want to slit, push edge slitters
away from form and tighten thumbscrews.
11. By pressing jog switch in forward position, advance
form through feed rollers until snap rollers grab the
form.
12. If necessary, adjust form length so the form starts
to burst when perforation is just under tear points.
NOTE: Tear points can be moved to position them at
any location along tear bar. Tear points should be set
between perforations that run vertically the length of
the form. (Fig. 25)
13
Advertisement
Table of Contents
