Table of Contents
Advertisement
OPERATION
1.
Place power switch in the "ON" position.
2.
To set the fold plate stop position, squeeze the
stop plate lever and move the stop plate to the
desired location on the upper and lower fold plates
(Fig 4). Align the pointed part of the stop plate with
the desired marks on the decal and release the lever.
Fine adjustments can be made with the adjustment
knob at the end of the plate (Fig 5).
NOTE: When doing a "Single" fold, be sure to move
the lower fold plate stop all the way to the front of
the plate. The plate must be firmly reinstalled on the
locating pins.
3.
Move the stacker wheels to the proper position for
the paper size (Fig 6) ( Refer to chart on page 7).
4.
Extend the telescoping conveyor stacker as required.
5.
Lift the in-feed tray extension into position.
6.
Raise the in-feed tray lever.
7.
Set the paper side guides for the paper you're using
and lock in position.
8.
Neatly stack paper on the in-feed tray.
9.
Lower the in-feed tray lever.
10.
Press the "Test" button on the control panel to check
the folds. Adjust as needed.
11.
If the fold is skewed use the skew adjustment knob
to make corrections (Fig.7).
12.
When you're satisfied with the test folds, press the
"Start" button to operate the machine.
Fig. 4
Fig. 5
Fig. 6
Fig.7
4
Stacker Wheel Positions A, B & C
Stacker Wheels
Skew Adjuster
Hide quick links:
Advertisement
Table of Contents
