Table of Contents
Advertisement
Once the unit and its components have been carefully removed from the packaging begin by attaching the
Output Conveyor, next install Fold Plates and then the Feed Table (2094) or Transfer Table & Burster (2084).
OUTPUT CONVEYOR INSTALLATION
1. Insert the output conveyor with the drive wheel
toward the seal rollers.
2. Slide the output conveyor over both sets of locating
pins. The first notch in the front part of the output table
should rest on the pins (Fig. 5a).
3. Drop the rear notch down on the rear dowel pins
(Fig. 5b).
4. Plug the output conveyor into the table receptacle
on the input/output power assembly. (Fig. 6)
NOTE: Do not operate machine without output
conveyor in place.
Fig. 5a
Conveyor locating pins
Fig. 5b
Fig. 6
5
Conveyor
connector
Advertisement
Table of Contents
