Feed Table Assembly Installation (2094) - Formax AutoSeal FD 2094 Operator's Manual

FEED TABLE ASSEMBLY INSTALLATION - 2094
(NOTE: For 2084, skip this process and go to page 8.)
1. Insert the feed table with the feed wheel toward the
fold rolls.
2. Slide the paper feed table over both sets of locating
pins. The first notch in the front part of the feed table
should rest on the pins (Fig. 9a).
3. Drop the rear notch down on the upper dowel pins
(Fig. 9b).
4. Rotate the hand wheel to check that the gears are
properly meshed (Fig. 10).
5. Connect the feed table hoses. Push the fittings into
the holes in the manifold block (Fig. 11).
6. Plug the feed table into the side of the frame. (Fig.
12)
NOTE: Do not operate machine without feed table in
place.
Locating
Pins
Fig. 9a
Fig. 9b
Fig. 10
USE OF THE HAND WHEEL: The hand wheel is
used to help clear jams and for setup. To use the
hand wheel, shut off the folder, pull out the hand
wheel and turn it in either direction.
Feed Table
Hoses
Air
Locating
Fig. 11
Pins
PUMP HOSE CONNECTIONS: Two sets of hoses
are included with your 2094, two (2) for the feed
table and two (2) for the pump.
Fig. 12
7
Hand Wheel
Feed Table Connector
Vacuum
Pump
Hoses