Table of Contents
Advertisement
Forms Creasing
Documents are wrinkled
or crunched
Forms in burster creep to
one side.
Burster stalls or tears
forms
Burster rollers don't
rotate / machine runs.
Won't burst properly.
Poor slitting.
Form is not exiting the folder
straight
Form is not entering the sealer
straight
Creasing continues
Fold plates are not inserted
correctly
Piece of paper or other material
is stuck in the fold plate
Infeed guides not set properly
Roller tension not uniform
across roller.
Tear bar in high position
Burster not running fast
enough
Incorrect form length setting
Tear points not adjusted
properly across face of form
Tough form perforations
Slipped belt
Broken drive belt
Loose pulley
Incorrect roller tension.
Carriage not properly
positioned.
Tear point not set correctly.
Tear bar not set correctly.
Slitter blades not making
contact with one another.
Worn blades.
Check that the forms are being fed
squarely.
Check that the eight ball track is sitting
properly.
Check to see if the fold rollers are clean.
Check that the eight ball track is sitting
properly.
Call service.
Remove and reinstall fold plates. Be
sure they're properly positioned.
Remove object from the fold plate.
Reset Guides, page 12
Check and adjust roller tension, Call
Service
Put bar in low position pg. 14
Increase burster speed
Reset paper length pg. 13
Adjust tear points pg. 13
Adjust tear points pgs. 13 - 14
Call Service
Check and adjust roller tension
Call Service
Reset carriage position
Adjust tear points pgs. 13 - 14
Adjust tear bar position pg. 14
Adjust slitter blade position, pg. 12
Replace blade, Call service
33
Advertisement
Table of Contents
