Unpacking & Set-Up; Burster Unpacking & Set-Up - Formax AutoSeal FD 2094 Operator's Manual

BURSTER ASSEMBLY - 2084
UNPACKING AND SET-UP
1. Remove bands which hold cardboard box to wooden
pallet. Remove top of box.
2. Remove (4) carriage bolts: (2) on infeed end of
burster and (2) outfeed end (Fig. 3a & 3b). Hint: Leave
carriage bolts in place on center burster support.
3. Remove (4) foam blocks.
4. With Allen wrench supplied, remove four retaining
bolts which hold machine to the board immediately
below it. NOTE: Center burster support is not fastened
to burster.
5. Add burster feet to burster. (Fig. 4)
6. Remove burster base from its carton.
7. Set burster on base. NOTE: Burster will line up
evenly on all sides of the base.
Fig. 4
Front view
Fig. 3a
Remove
Rear view
Fig. 3b
Burster
4
Remove
Burster Base