Table of Contents
Advertisement
RATE
The "RATE" button is used to display the average pieces per
hour, both current and average since the last total counter
reset.
Pressing the "RATE" button will change the display to the
rate screen consisting of two lines. The top line is the current
rate. It will have a 5 digit display, and will refresh every 6
seconds. The second line will show the average pieces per
hour since the last total counter reset. This line will also
have a 5 digit display, and refresh every 30 seconds.
The display will stay in this mode until another mode button
is pressed. The "ENTER" and "RESET" buttons will have no
effect in this mode.
NOTE: Every time the total count is reset the average rate
per hour will also be reset.
NOTE: If a button is not pressed within 2 minutes, the
machine will return to operating mode.
RUN TIME
The "TIME" button will display the time since the last total
count reset and the total hours that the main drive has been
on, the customer can not reset this meter. Both hour meters
will increment only when the folder is running. The pump
operation or the main power will have no effect on these
meters.
NOTE: Every time the total count is reset the job run time
should also be reset.
Pressing the "TIME" button will change the display to the
time mode.
In this mode the first line of the display will show job run
time and have a 4-digit capability to show the number of
hours since last reset. The second line will show total hours
and have a 6-digit capability to show the total hours on the
machine.
The "COUNT" button can be used to go back into the count
screen from the rate screen.
NOTE: If a button is not pressed within 2 minutes, the
machine will return to operating mode.
START/STOP BUTTON - DRIVE MOTOR
In the normal operating mode pressing the DRIVE button will
activate the main drive motor and the LED below the button
will light. Pressing the DRIVE button again will deactivate
the main drive motor and turn off the LED.
START/STOP BUTTON - PUMP
In the normal operating mode pressing the PUMP button
will activate the pump motor, and the LED below the button
will light. Pressing the PUMP button again will deactivate
the pump motor and turn off the LED.
20
Advertisement
Table of Contents
