Formax AutoSeal FD 2094 Operator's Manual page 38

Forms pull out of burster
tractors.
Large variations in trim
accuracy
Snap roller carriage will
NOT move
Loop forming between
the slitter and the infeed
roller.
Roller timing is off
Incorrect form length setting
Incorrect feed roller tension
Tractor drive pulley bound up
Tractors binding internally
Tractor pins not centered in
margin holes
Dull slitter blades
Tractor timing is off
Paper not centered to slitter
feed
Margin slitter setscrew not
tightened down
Defective switch or motor
Broken carriage drive chain
Loose setscrew on carriage
advance shaft or on motor
Obstruction on rack
Obstruction at the pivot arm
Obstruction between the
infeed and snap rollers
Broken flow strap
Bent infeed finger
Tear bar in low position
Too many tear points
Need Anti-tenting bracket
Call service.
Reset form length pg. 13
Check and adjust roller tension, Call Service
Check for paper jam and clear, Call service.
Call service.
Adjust tractors pg. 13
Replace blade, Call service
Call service.
Realign paper
Tighten setscrew
Call Service
Call Service
Tighten setscrew, Call service
Remove obstruction
Remove obstruction
Remove obstruction
Call Service
Call Service
Put bar in high position pg. 14
Adjust tear points pgs. 13 - 14
Call Service
34