1. GENERAL INFORMATION
Do not squeeze wires against the weld or
its clamp.
After clamping, check each harness to
make sure that it is not interfering with any
moving or sliding parts.
When fixing the wire harnesses, do not
make it contact the parts that will generate
high heat.
Route wire harnesses to avoid sharp
edges or corners.
ends of bolts and screws.
Route wire harnesses passing through the
side of bolts and screws.
projected ends of bolts and screws.
Route harnesses so they are neither
pulled tight nor have excessive slack.
1-5
Do not pull
too tight!
Avoid the projected
Avoid the
No Contact
Protect wires and harnesses with electrical
tape or tube if they contact a sharp edge
or corner.
When rubber protector cover is used to
protect the wire harnesses, it shall be
installed securely.
Do not break the sheath of wire.
If a wire or harness is with a broken sheath,
repair by wrapping it with protective tape or
replace it.
When installing other parts, do not press
or squeeze the wires.
After
routing,
check
harnesses are not twisted or kinked.
Do not press or
squeeze the wire
X -Town 125 ABS/ CBS
that
the
wire