KYMCO X -Town 125 ABS Service Manual page 130

10. A.C. GENERATOR/STARTER CLUTCH
INSTALLATION
Install the starter driven gear onto the
crankshaft.
Apply oil to the starter reduction gear shaft.
Install the starter reduction gear and shaft to
the right crankcase.
Install the flywheel onto the crankshaft by
aligning the key on the crankshaft with the
groove in the flywheel.
＊
Before installation, check and make sure
that the inside the flywheel is not
contaminated.
10-7
X -Town 125 ABS/ CBS
Starter Driven Gear
Shaft Reduction Gear
Key Flywheel Groove