Table of Contents
Advertisement
PART 1
warning:
7.4 Recording functions
The receiver supports instant recording, recording via timer and recordings booked via the Electronic
Programme Guide (EPG). First select the storage device on which you like to store the recordings
before you can use the recording functions. Connect the storage device and select PVR settings in the
DTV settings menu. After you have made recordings you can watch them by selecting the option PVR
from the DTV menu.
Press OK to open this menu. Select the recording you want to watch. At the right side of this menu
you can see the date and size of the recording. Press OK to start playback and use the multimedia
buttons for forwards, backwards, pause and stop. Press the ReD Delete button to remove the
selected recording from the list.
7.5 installation
In this menu you can select a satellite and setup the corresponding settings for installing and
searching for channels. Below you will find level and quality bars for optimizing the best signals of
your dish.
Use pq to select one or more satellites. Press OK to mark or unmark them. When ready with your
selections, press u to jump to the right side of screen where you can select a satellite and add the
corresponding settings as DiSEqC ports.
At the end of the setup you can start the scan process by pressing the bLue Scan button.
SAT
TP
LNB type
LNB voltage
SatCR
LNB Power
22KHz
ToneBurst
A factory reset will permanently delete all your personal settings, timers
and stored channels. The Android part is kept as it is. Please consider this
before you perform a factory reset.
Select a satellite with tu. If you only mark one satellite you cannot select
another.
Select a transponder if you want to scan or adjust the dish on a selected
frequency. Press OK to call the overview list.
Default is set to 9750/10600 which is the most common setting for LNBs
(Universal type). Select another if you are using a different type LNB which
needs other values.
Select On to increase the LNB voltage if you use a long coaxial cable to
compensate for decrease of the LNB supply voltage.
Select one of the frequencies if you are connected to a SatCR system. SatCR is
a special system which mainly is used in apartment buildings to provide one
satellite dish system to many users at once. To use this function, contact your
property management or system installer. If SatCR is activated, other settings
below are not used. For normal use, default is set to Off.
Default is set to 13/18V. The others functions are intended for specialized staff
only.
Select Off or On if you use a special dish setup. For normal use this is default
set to Auto.
If you are using a legacy type switch to switch between 2 satellites, setup
your port to the satellite you selected above.
19
Advertisement
Table of Contents
