AM Series Boilers and Water Heaters User Manual
CHAPTER 10 – MAINTENANCE
10.14 Removing the Unit Covers
In order to remove the unit covers, refer to Figure 10-1 and follow the steps below:
Lift up, by hand, the Top Cover "A".
1.
Remove two Front Cover screws "B".
2.
Pull back the upper part of Front Cover "C" for 2 inches, then pull it up for one inch and
3.
remove it from the unit.
Pull back upper part of Bottom Cover "D" for 2 inches, then pull it up for one inch and
4.
remove it from the unit.
5.
To gain access to the junction box:
a) Remove the Junction Box Cover screw "E" at rear of cover.
b) Remove Junction Box cover "F".
(F) Junction
Box Cover
Figure 10-1: Removing the Top and Front Covers
OMM-0100_E • GF-146 • 11/15/2019
Removing the Unit Covers
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
(A) Top Cover
(E) Junction Box Screw
(B) Front Cover
Screws (2 each)
(C) Front Cover
(D) Bottom Cover
Page 128 of 170