Unpacking The Device - Siemens SIMATIC ET 200SP Operating Instructions Manual

Application planning
5.2 Unpacking the device
5.2

Unpacking the device

When unpacking
When unpacking, make sure to check the following:
• Check packaging and contents for visible damage from transport. Damaged or incomplete
devices should never be commissioned.
• Check the delivery for correctness and completeness.
Please inform your Siemens contact partner should you notice any irregularities.
• Keep the supplied documentation and licenses. They belong to the device and are the proof
that you have purchased the software preinstalled on the CFast card. Documentation and
licenses are required for initial commissioning and for any questions that arise.
• Keep the original packaging in case the device needs to be transported again.
• Note the identification data (Page 35) of the device.
NOTICE
Damage to the device during transport and storage
If a device is transported or stored without packaging, it is unprotected from shocks, vibrations,
pressure and moisture. Damaged packaging indicates that environmental conditions have
already had a significant impact on the device.
The device might be damaged.
Do not dispose of the original packaging. Pack the device for transport and storage.
NOTICE
Damage to the device caused by condensation
If the device was exposed to low temperatures or extreme variations in temperature during
transport, this may cause moisture to build up on or in the device (condensation). Please note
the specified mechanical and climatic ambient conditions (Page 86).
Moisture can cause short-circuits in the electrical circuits and damage the device.
Proceed as follows to avoid damage:
• Store the device in dry conditions.
• Make sure it adapts to room temperature before commissioning.
• Do not expose the device to direct heat radiation from a heater.
• If condensation has developed, wait until the device is completely dry before you switch it
34
on.
CPU 1515SP PC2 (F/T/TF)
Operating Instructions, 03/2023, A5E42603425-AC