Table of Contents
Advertisement
RUGGEDCOM WIN5123
Installation Guide
Installing the Device
This chapter describes how to install the device, including mounting the device, connecting power, connecting the
antenna, and connecting the device to the network.
DANGER!
Electrocution hazard – risk of serious personal injury and/or damage to equipment. Before performing
any maintenance tasks, make sure all power to the device has been disconnected and wait
approximately two minutes for any remaining energy to dissipate.
DANGER!
Electrocution hazard – risk of death or serious injury. When the base station is installed in an outdoor
location, all indoor components (e.g. Ethernet and power supply) should be connected through a
lightning protector.
Lightning protection protects people and equipment located indoors from lightning that may strike the
base station or its outdoor cables. Therefore, install the lightning protector base station indoors, as
close as possible to the point where the cables enter the building. The lightning protector can also be
installed outdoors as long as the cables that lead indoors are well protected from lightning between the
protector and the building entrance.
WARNING!
Safety hazard – risk of serious personal injury and/or damage to equipment. Installing the
RUGGEDCOM WIN5123 can pose a serious safety hazard. Be sure to take precautions to avoid the
following:
• Exposure to high voltage lines during installation
• Falling when working at heights or with ladders
• Injuries from dropping tools
• Contact with AC wiring (power system connection)
IMPORTANT!
Only certified personnel should be permitted to install equipment.
IMPORTANT!
This product contains no user-serviceable parts. Attempted service by unauthorized personnel shall
render all warranties null and void.
Changes or modifications not expressly approved by Siemens Canada Ltd. could invalidate
specifications, test results, and agency approvals, and void the user's authority to operate the
equipment.
IMPORTANT!
This product should be installed in a restricted access location where access can only be gained by
authorized personnel who have been informed of the restrictions and any precautions that must be
taken. Access must only be possible through the use of a tool, lock and key, or other means of security,
and controlled by the authority responsible for the location.
Chapter 2
Installing the Device
7
Advertisement
Table of Contents
