Table of Contents
Advertisement
Replacing a Fuse
Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the
fuse burns out, the product will not function whatsoever. If this happens,
so.
1.
Unplug the unit from electric power source.
2.
Insert a flat-head screwdriver into a slot in the fuse cover. Gently pry up the fuse cover. The fuse will
come out.
3.
Remove the used fuse. If brown or unclear, it is burned out.
4.
Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover. Be sure to
use a fuse of the same type and specification. See the product specification label for details.
Replacing a Gobo from the rotating Gobowheel
1. Disconnect mains power supply and set the switch to OFF.
2. Make sure that the gobo you want to insert has the same size. For the right size, see below.
Gobo Size
3. Before removing the top part of the housing, make sure the lens is in the position as shown on the left.
The lens position should be on the bottom, symmetrically speaking.
4. Loosen the 4 screws on the back of the housing.
5. Gently tilt the head so the small metal housing will slide out more easy.
6. Turn the gobo wheel, with the gobo you want to remove, to the upside.
follow the directions below to do
Fig. 8
27
Fig. 7
Advertisement
Table of Contents
