External Control
Tap and Infinite Mode Jumper Switch Configuration
You can use your Strymon MiniSwitch (sold separately) or an external,
non-latching (momentary) type switch to access Brig's Tap Tempo and
Infinite Mode features�
The Strymon MiniSwitch includes an internal jumper switch that must
be changed from its factory FAV/BOOST Mode setting to work for
Brig's Tap and Infinite switching� Follow these steps to configure the
MiniSwitch's jumper switch�
1
Unscrew the four screws on the bottom of the MiniSwitch chassis�
2
Once opened, locate the small jumper underneath the circuit board
and change it from the center and right pins (FAV/BOOST) to the
center and left pins (TAP)�
Close-up view of the MiniSwitch circuit board jumper switch
TAP
FAV/BOOST Mode
For Brig's Favorite Switch mode—place
the jumper on the two RIGHT pins� (This
is how MiniSwitch is configured from
the factory�)
3
Once the jumper configuration is complete, secure the cover back
on your MiniSwitch� See the following External Tap and Infinite Mode
setups to configure your external footswitch�
FAV/BOOST
TAP
FAV/BOOST
TAP Mode
For Brig's Tap and Infinite Switch
functionality—place the jumper on the
two LEFT pins�
pg 19