Table of Contents
Advertisement
External Control
Freeze or Infinite Mode Switch Setup
You can use your Strymon MiniSwitch or an external, non-latching
(momentary) type switch to access the cloudburst Freeze or Infinite
modes�
The Strymon MiniSwitch includes an internal jumper switch that must
be changed from its factory FAV/BOOST Mode setting to work for the
cloudburst Freeze or Infinite momentary switch functionality� Follow
these steps to configure the MiniSwitch's jumper switch and cloudburst's
EXP/MIDI jack for Freeze or Infinite functionality�
1
Unscrew the four screws on the bottom of the MiniSwitch chassis�
2
Once opened, locate the small jumper underneath the circuit board
and switch it from the center and left pins (FAV/BOOST Mode) to the
center and right pins (TAP Mode)�
Close-up view of the MiniSwitch circuit board jumper switch
TAP
FAV/BOOST Mode
For cloudburst's Favorite Switch
mode—place the jumper on the two
RIGHT pins� (This is how MiniSwitch is
configured from the factory�)
3
Once the jumper configuration is complete, secure the cover back on
your MiniSwitch�
4
Configure cloudburst's EXP/MIDI jack for the Freeze or Infinite mode
as desired� (See
5
Connect your MiniSwitch (or, optionally, a momentary switch with a
TRS cable) to the EXP/MIDI jack�
FAV/BOOST
page 11
for more info�)
TAP
FAV/BOOST
TAP Mode
For cloudburst's Freeze or Infinite
Switch modes—place the jumper on the
two LEFT pins�
pg 16
Hide quick links:
Advertisement
Table of Contents
