Led Brightness - Strymon BRIG User Manual

LED Brightness

You can adjust the brightness of Brig's LED to optimize visibility in any
environment or lighting conditions�
1 Press and hold the FOOTSWITCH for at least 2 seconds while powering
up Brig� Once the LED flashes RED, release the footswitch�
2 Press and hold the FOOTSWITCH again and turn the MOD
BRIGHTNESS) knob to adjust the brightness of the LED from low to
high (the default)� Release the FOOTSWITCH when your adjustment
is complete�
3 Press and release the FOOTSWITCH to store the LED Brightness
setting and begin using Brig�
NOTE: The LED Brightness setting persists across power cycles and is not
saved per preset�
3005
3205 multi
TIME VOICE
FILTER REPEATS
dBucket Delay
hold (tap)
MIX
MOD
(LED
pg 12