Strymon BRIG User Manual page 41

Power Up Modes - Quick Reference
Global parameters and functions can be accessed via a power up
procedure� All power up functions persist through power cycles�
1 Press and hold theBrig FOOTSWITCH for at least 2 seconds while
powering up Brig� Once the LED flashes RED, release the FOOTSWITCH�
2
Adjust the desired functions with the controls noted below�
3 Press the FOOTSWITCH to store your changes and exit Power Up Mode�
POWER UP MODE
BYPASS MODE
FOR MONO I/O
See page 9
for an illustrated
description�
SPILLOVER MODE
See page 10
for an illustrated
description�
DRY SIGNAL
See page 11
for an illustrated
description�
LED BRIGHTNESS
See page 12
for an illustrated
description�
EXP/MIDI JACK
MODE
See page 13
for an illustrated
description�
*NOTE: Also see
pedal functionality per preset�
Set the VOICE switch - status shown on the LED
• True Bypass: switch in the 3205 (left) or 3005
(middle) position - LED
• Buffered Bypass: switch in the multi (right) position
- LED RED
Turn the MOD knob - status shown momentarily on the
LED
• Off: AMBER
• ON: PURPLE
Turn the REPEATS knob - status shown momentarily on
the LED
• Digital: GREEN
• Analog: RED
• Kill Dry: BLUE
Press and hold the footswitch again and turn the MOD
knob to adjust the brightness of the LED�
Turn the MIX knob - status shown on the LED
• Expression:
• Favorite: AMBER
• Tap: RED
• Infinite: PURPLE
• MIDI: BLUE
MultiSwitch Plus)
"Expression Pedal Setup" on page 16
OPTIONS
GREEN
(default, minimum knob position)
(maximum knob position)
(default, minimum knob position)
(12 o'clock knob position)
(maximum knob position)
GREEN (default, minimum knob position)*
(11 o'clock knob position)
(12 o'clock knob position)
(2 o'clock knob position)
(maximum knob position, also for using
(default)
to configure your
pg 41