Power Up Modes
Spillover Mode
Setting Brig to Spillover Mode allows the wet delay signal of the
currently selected preset to "spill" into bypass—or into the next loaded
preset if you're using a Multiswitch Plus or MIDI for preset switching�
NOTE: Because of the buffer architecture, the current preset must be active
for at least 5 seconds before Spillover between presets will be operational�
Spillover is available immediately when bypassing the effect�
1
Press and hold the FOOTSWITCH for at least 2 seconds while powering
up Brig� Once the LED flashes RED, release the footswitch�
2
Turn the MOD
off� The LED will change color to indicate the current status as you
turn the knob�
• Spillover Mode Off:
• Spillover Mode On:
NOTE: When Spillover is set to On, Bypass Mode is set to Buffered Bypass�
3
Press the FOOTSWITCH to store the Spillover Mode setting and begin
using Brig�
NOTE: The Spillover Mode setting persists across power cycles and is not
saved per preset�
3205
TIME
VOICE
FILTER
REPEATS
dBucket Delay
hold (tap)
(SPILLOVER
MODE) knob to set Spillover Mode on or
AMBER
(default, minimum)
PURPLE
3005
multi
MIX
MOD
(maximum)
pg 10