Tap Mode Switch Setup - Strymon ULTRAVIOLET vintage vibe User Manual

External Control

Tap Mode Switch Setup

Optionally, you can use your Strymon MiniSwitch or an external, non-
latching (momentary) type switch to access UltraViolet's Tap mode� This
allows you to "tap" in a tempo to which UltraViolet's LFO can sync�
The Strymon MiniSwitch includes an internal jumper switch that must
be changed from its factory FAV/BOOST Mode setting to work for the
UltraViolet Tap Mode momentary switch functionality� Follow these steps
to configure the MiniSwitch's jumper switch and EXP/MIDI jack�
1
Unscrew the four screws on the bottom of the MiniSwitch chassis�
2
Once opened, locate the small jumper underneath the circuit board
and change it from the center and right pins (FAV/BOOST Mode) to the
center and left pins (TAP Mode)�
Close-up view of the MiniSwitch circuit board jumper switch
TAP
FAV/BOOST Mode
For UltraViolet's Favorite Switch
mode—place the jumper on the two
RIGHT pins� (This is how MiniSwitch is
configured from the factory�)
3 Once the jumper configuration is complete, secure the cover back on
your MiniSwitch�
4 Configure UltraViolet's EXP/MIDI jack for Tap Mode� (See
for more info�)
5
Connect your MiniSwitch (or, optionally, a momentary switch with a
TRS cable) to the EXP/MIDI jack�
FAV/BOOST
TAP
FAV/BOOST
TAP Mode
For UltraViolet's Tap Switch mode—
place the jumper on the two LEFT pins�
page 9
pg 14