Table of Contents
Advertisement
External Control
Expression Pedal Setup
Use a TRS expression pedal to remotely control the knobs of Brig� By
default, Brig is configured so that an Expression pedal controls the MIX
knob�
1
Configure the EXP/MIDI jack for Expression Mode� (See
configuration instructions�)
2
Connect an expression pedal to the EXP/MIDI jack of Brig using a TRS
cable�
3
Press and hold the FOOTSWITCH for at least 3 seconds, until the
LED blinks GREEN�
4
Rock your expression pedal to the HEEL position� The
will stop blinking and remain lit�
5
Set the knob(s) you would like to control to the desired settings for the
HEEL position of the expression pedal�
6
Rock the expression pedal to the TOE position� The LED will turn RED�
7
Set the knob(s) you would like to control to the desired settings for the
TOE position of the expression pedal�
8
Press and release the Brig FOOTSWITCH to exit and store your
expression pedal setup�
NOTE: Your expression pedal assignment is saved per Favorite setting or
MIDI preset�
NOTE: If Brig is set to respond to MIDI EXPRESSION and the EXP/MIDI jack is
set to MIDI Mode, you can send MIDI CC# 100 with values 0 (heel) to 127 (toe)
to perform the expression pedal setup�
page 13
RIGHT IN
LEFT OUT
RIGHT OUT
GREEN
for
USB
EXP
MIDI IN
MIDI OUT
LED
pg 16
Advertisement
Table of Contents
