Table of Contents
Advertisement
Power Up Modes
Dry Signal
The Dry Signal can be set in one of three different ways�
• Digital Mode uses the converted dry signal and allows the MIX knob to
dial out the dry signal when turned past the 3 o'clock position�
• Analog Mode keeps the dry signal in analog�
• Kill Dry Mode mutes the analog dry path signal, allowing the MIX
knob to strictly control the "wet" effect output level� This is often
preferable if using Brig within an amp's parallel effects loop or a
mixer's aux or effects send�
1
Press and hold the FOOTSWITCH for at least 2 seconds while powering
up Brig� Once the LED flashes RED, release the footswitch�
2
Turn the REPEATS
Signal options� The LED will change color to indicate the current
status as you turn the knob�
• Digital Mode:
• Analog Mode:
• Kill Dry Mode:
3
Press the FOOTSWITCH to store the Dry Signal setting and begin using
Brig�
NOTE: The Dry Signal setting persists across power cycles and is not saved
per preset�
3005
3205
TIME
VOICE
FILTER
REPEATS
dBucket Delay
hold (tap)
(DRY
SIGNAL) knob to select one of the three Dry
GREEN
(default, minimum)
RED
(12 o'clock)
BLUE
(maximum)
multi
MIX
MOD
pg 11
Advertisement
Table of Contents
