Tap Switch - Strymon DECO User Manual

Deco
- Tape Saturation & Doubletracker User Manual
Expression Input Modes
The EXP jack on your Deco is set up for Expression Pedal from the factory.
To change the Expression Input mode, hold down both Saturation Bypass
and Doubletracker Bypass switches while powering up. While holding
down, turn the Saturation knob to one of three ranges shown below.
EXPRESSION PEDAL
Set to Expression pedal mode
and connect a standard TRS
expression pedal for control over
any knob.
To assign the knob controlled
by the expression pedal: Power
down your pedal. Hold the TAPE
SATURATION BYPASS footswitch
during power up, while turning
the knob you'd like to assign.
The maximum position the knob
is turned up to becomes the
expression pedal "toe down"
maximum value.

TAP SWITCH

Set to Tap switch mode
and connect an external
tap switch to tap in your
Lag Time. Tapping quarter
notes sets the Lag Time to
8th notes.
HOLD BOTH AT POWER UP while turning the
SATURATION knob to set Expression Input Mode
FAVORITE SWITCH
Set to Favorite switch mode and
plug in a Favorite switch to save
and recall a favorite preset. To
save a favorite setting, press and
hold the Tape Saturation Bypass
button.
®
pg 7