Assembly Instructions For The Tilt System Accessories; Parts Of The Tilt System Assembly; Tools To Assemble The Tilt System - GIRBAU HS-6085 Installation Instructions Manual

5. ASSEMBLY INSTRUCTIONS FOR THE TILT SYSTEM ACCESSORIES

DANGER!
TILT SYSTEM
To assemble the
Take special care as this machine's weight and volume is considerable.

Parts of the tilt system assembly

DESCRIPTION
Hinge assembly to the frame base (Figure 39)
Tilt hinge ......................................................................................... 4
Screw M14x55 ................................................................................. 16
M14 Self-blocking nuts ........................................................................ 16
ø 15 washers ................................................................................... 32
Levelling supplement ........................................................................... 6
Hold down base assembly (Figure 40)
Hold down base ................................................................................. 2
Hold down base ................................................................................. 2
ø 16 mm metallic stud ......................................................................... 12
ø 13 x 34 Washers ............................................................................. 12
HS-6057, EH130. Beam assembly to the frame (Figures 41/42)
Pneumatic actuator, fixing plates, beams set ............................................... 2
M12x90 screw ................................................................................... 8
M12 Self-blocking nuts ......................................................................... 8
ø 13 washers ................................................................................... 16
HS-6085, HS-6110, EH190, EH255. Beam assembly to the frame (Figures 41/42)
Pneumatic actuator, fixing plates, beams set ............................................... 2
M14x130 screws ................................................................................ 8
M14 Self-blocking nuts ........................................................................ 8
ø 15 washers ................................................................................... 16
Tilt system guards(Figure 44)
Front guard ...................................................................................... 1
Rear guard ....................................................................................... 1
Side guard ....................................................................................... 2

Tools to assemble the tilt system

To assemble the tilt supplement accessories, a part from the tools indicated in section 1.2, the following tools
are required:
 flat spanner 7/8 in (22 mm)
 offset ring wrench 7/8 in (22 mm )
 flat spanner 3/4 in (19 mm) (only HS-6057, EH130 models)
 offset ring wrench 3/4 in (19 mm) (only HS-6057, EH130 models)
 drill for base holding down: 0.67 in. (17 mm) diameter.
Tilt system assembly
elements, machine must be moved.
QUANTITY
Cod. 511485
Rev. 10/0918
47