Danfoss VLT 3006 Product Manual page 123

Parameter description
605
Personal display select
(Display select)
650
VLT type
(VLT type)
122
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Value:
Standard display (standard disp.) [0]
Reference % (reference %)
Frequency Hz (frequency Hz)
Feedback unit (feedbk 'unit')
Current A (current A)
Torque % (torque %)
Power kW (power kW)
HP power (power HP)
Energy kWh (energy kWh)
Output voltage VLT (out/volt V)
DC voltage VLT (DC bus)
VLT therm % (ETR (VLT) %)
Motor therm % (ETR (MOT) %)
Running hours (run hours)
Input status "binary code"
(input status)
= Factory setting. Text in ( ) = Display text.
The figures in [ ] are used in bus communication.
®
MG.30.A7.02 - VLT is a registered Danfoss trademark
6.. Service and diagnostics
Function:
You can have two different display
[1] read-outs in the display at the same time.
[2] The extra read-out selected in this para-me-
ter will be shown in line 2 of the display.
[3]
[4]
[5] Description of choices:
[6] Standard display is selected for normal
[7] reading of e.g. the frequency in Hz in line 1,
indication of ''frequency" in line 2 and indi-
[8]
cation of status of operation in line 3. The
[9]
other data values are selected to read an-
[10]
other operation value in line 2, so that the
[11]
aforementioned frequency in line 1 and cur-
[12]
rent in line 2 simultaneously is possible.
[13]
There are 14 different data values to select
between.
[14]
Note that to be able to see both lines si-
multaneously, the display must be in
Display mode.
Function:
Used to indicate which unit the control card
is placed in, in cases where the control card
cannot decide for itself, or to select voltage
range in multi-voltage units if the factory
setting deviates from what is required.
Description of choices:
The parameter is used to select the correct
VLT ® type/size/voltage for VLT
®
3250 and VLT types 3575-3800, which are
multi-voltage units. If the factory-set voltage
does not correspond to the voltage in the
application for which the unit is used, the
following procedure is used.
1) Select the required VLT
type/size/voltage.
2) Select parameter 604, data value
initialization.
3) Disconnect mains voltage and wait for
the light in the display to disappear.
4) Connect mains voltage.
Note that during start-up the display
shows the selected new data.
® types 3060-
®