JLG ES1330L Operation & Safety Manual page 76

Accessories
5.6.2 Preparation and Inspection
Pre-Operation Inspection:
1. Inspect each of the SkySense tubes for dents, cracks, or other damage.
2. Inspect each SkySense sensor for any damage to the housing or sensor.
To test the SkySense system:
1. Ensure there are no obstructions within 10 feet around or above the platform and
the machine is on a smooth, firm surface within the limits of the maximum
operating slope.
2. From the platform control console, lift and lower the platform.
3. Place a hand or object above one of the sensors, then lift up the platform.
Platform movement should stop, the LED indicator should be red, and the alarm
should sound. If the alarm is muted, the mute button light should be red.
4. Release the joystick and enable switch.
5. Place a hand or object above one of the sensors. Press the override button on the
notification unit and lift the platform. The platform should lift, the LED indicator
should be red, and the alarm should sound. If the alarm is muted, the mute button
light should be red.
6. Remove hand or object from the sensor zone, then release the joystick and enable
switch. Lower the platform to stowed.
7. Lift the platform with no hand or object above the sensor. The platform should lift
without interruption.
8. Lower the platform to stowed.
5.6.3 Operation
SkySense slows a machine's function speed to creep speed when it is a certain distance
away from an object, known as the "warning zone." If the machine continues to
approach the object and moves into the "stop zone," SkySense stops all machine
functions.
For proportional functions that are activated by the joystick, the size of the warning
zone varies based on the amount of joystick activation. The stop zone always activates
at the same distance from the object regardless of the joystick's position.
SkySense is active during the following functions:
• Lift Up
• Drive Forward
• Drive Reverse
76
31221553 ES1330L, ES1530L