JLG ES1330L Operation & Safety Manual page 28

User Responsibilities, Machine Preparation, and Inspection
2. Structure – Inspect the machine structure for dents, damage, weld or parent
metal cracks or other discrepancies.
Report this to the proper maintenance personnel.
Figure 1. Parent Metal Crack
3. Decals and Placards – Check all for cleanliness and legibility. Ensure none of the
decals and placards are missing. Ensure all illegible decals and placards are
cleaned or replaced (refer to
4. Operation & Safety Manuals – Ensure that a copy of the Operation & Safety
Manual, AEM Safety Manual (ANSI markets only), and ANSI Manual of
Responsibilities (ANSI markets only) is enclosed in the weather resistant storage
container.
5. Walk-Around Inspection – Perform as instructed in
Inspection.
6. Battery – Charge as required.
7. Hydraulic Oil – Check the hydraulic oil level in the pump reservoir, add as
required (refer to
8. Accessories/Attachments – Refer to the Accessories section in this manual or the
accessory installed upon the machine for specific inspection, operation, and
maintenance instructions.
9. Function Check – Once the Walk-Around Inspection is complete, perform a
functional check of all systems in an area free of overhead and ground level
obstructions. Refer to
more specific instructions on the operation of each function.
10. Platform Gate – Keep gate and surrounding area clean and unobstructed. Ensure
the gate closes properly and is not bent or damaged. Keep gate closed at all times
except when entering/exiting the platform and loading/unloading materials.
11. Lanyard Attach Points – JLG Industries, Inc. recommends personnel in the
platform wear a full body harness with a lanyard attached to an authorized
lanyard anchorage point.
28
Section – Decal
Section – Operator Maintenance).
Section – Machine Controls, Indicators, And Operation
31221553
Figure 2. Weld Crack
Installation).
Section – Walk-Around
for
ES1330L, ES1530L