Control Modes; One Bumper Strobe (Static Mode); One Bumper Strobe (Strobe Mode); Remote Control - SHOWTEC Bumper Strobe V1 Manual

Bumper Strobe

Control Modes

There are 2 modes:

One Bumper Strobe (Static mode)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) The Bumper Strobe functions as a stand-alone device. See page 10 for more information about
Static mode.

One Bumper Strobe (Strobe mode)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) The Bumper Strobe functions as a stand-alone device. See page 10 for more information about
Strobe mode.

Remote Control

Ordercode: 30873
• Static mode
• Strobe mode
9
Fig. 03