Table of Contents
Advertisement
Bumper Strobe
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
No Light
If the light effect does not operate properly, refer servicing to a technician.
Suspect three potential problem areas as: the power supply, the LEDs, the fuse.
01) Power supply. Check if the unit is plugged into an appropriate power supply.
02) The LEDs. Return the Bumper Strobe to your Showtec dealer.
03) The internal fuse. Return the Bumper Strobe to your Showtec dealer.
04) If all of the above appears to be O.K., plug the unit in again.
05) If you are unable to determine the cause of the problem, do not open the Bumper Strobe, as this
may damage the unit and the warranty will become void.
06) Return the device to your Showtec dealer.
Problem
Probable cause(s)
One or more
No power to the fixture.
fixtures do not
function at all
Internal fuse blown.
Fixture is too hot.
No light or LEDs
cuts out
LEDs damaged
intermittently
The power supply settings do not
match local AC voltage and
frequency.
Ordercode: 30873
Remedy
●
Check if power is switched on and
cables are plugged in.
●
Return the device to your Showtec
dealer.
●
Allow fixture to cool.
●
Clean fan.
●
Make sure air vents are not blocked.
●
Turn up the air conditioning .
●
Disconnect fixture and return to your
dealer.
●
Disconnect fixture. Check settings and
correct if necessary.
11
Advertisement
Table of Contents
