Changing The Engine Oil - Wacker Neuson RS600A Operator's Manual

RS600A
5.5

Changing the Engine Oil

Requirement The requirements for this procedure are:
Engine warm
Fresh oil
Procedure Perform the procedure below to change the engine oil.
1. Drain the oil while the engine is still warm.
2. Remove the oil filter plug (a) and the drain plug (b) to drain the oil.
Note: In the interest of environmental protection, place a plastic sheet and a
container under the machine to collect any liquid that drains off. Dispose of this
liquid in accordance with environmental protection legislation.
3. Install the drain plug.
4. Fill the engine crankcase with the recommended oil up to the level of the lug
opening (c). See chapter Technical Data for oil quantity and type.
5. Install the oil filler plug.
wpm_tx001561gb.fm
a
c
b
wc_gr000028
33
Maintenance
a
wc_gr000022