Table of Contents
Advertisement
select a stream and confirm with OK. The audio channel as stereo, mix, left and right can be selected
with t u.
6.4 Teletext
Your receiver includes a fully featured Teletext. To access Teletext, press TEXT in viewing mode and
use the 0~9 buttons to enter the number of the page you wish to see. Use pq to select one page up
or down, use t u to select subpages. Press or TEXT to get back to viewing mode.
6.5 Subtitles
Some channels support a choice of subtitle languages. Press SUB in viewing mode to display a list of
available subtitle languages. Select your subtitle of choice with pq and press OK to confirm. Press
to leave without making changes.*
* Availability of DVB/Hard of Hearing subtitles depends on the broadcast. If subtitles are not present, then, they can be
activated via Teletext.
6.6 EPG (Electronic Programme Guide)
The Electronic Programme Guide is a very useful function that allows you to view event schedules
and programme information and to mark events/movies for wakeup of the receiver. To access the
EPG, press EPG in viewing mode. Use pq to select a channel and t u to select an event. Press OK
to display detailed information of the selected event. Use 9 to quit the detailed information screen.
Press the RED or GREEN buttons to see and select another day. Press the YELLOW button to set a
timer for a selected event. Refer to section 7.3.6 for details of the timer function.
NOTE:
Availability of EPG data depends on broadcast.
6.7 Record, Timeshift and Format
To use these functions you must connect a USB memory device to the USB port at the rear panel.
For best performance, especially of HD content, we advice to use Hard Disk drives USB 2.0 or higher.
These must be formatted in FAT32 format, otherwise Record and Timeshift function will not work.
6.7.1 Instant recording
To immediately record a programme, press 4 to start the recording and press 3 to quit.
6.7.2 Timeshift
If you want to use the Timeshift function you only need to press 2 in viewing mode. To resume
timeshifted content, press u or 2 again. During the playback you can use the 5 6 or 2 buttons. To
stop the Timeshift mode, press 3 and it will jump to the actual time of the live signal. The function
will still be running in the background and as long you do not switch to another channel it is possible
to jump again to the beginning by pressing 2 again. Also, with t u it is possible to jump in time
during Timeshift modes. Default is set to 20 seconds. Press the GREEN Jump Set button to change the
jump time.
11
Advertisement
Table of Contents
