Adjusting Toe-In (Y); Adjusting Toe-In (Y); Checking Radiator Hose And Clamp (Z); Checking Radiator Hose And Clamp (Z) - Kioti CS2510H Operation Instructions Manual

ADJUsTING TOE-IN (y)

ADJUsTING PROCEDURE
(a) wheel - to - wheel distance at front
(B) wheel - to - wheel distance at rear
1. Park tractor on a flat level area.
2. turn steering wheel so front wheels
are pointed straight ahead.
3. lower the implement, lock the
parking brake and stop the engine.
4. measure distance between tire
beads (center) at front of tire and
hub height.
5. measure distance between tire
beads at the rear of tire and hub
height.
6. front distance should be 0.08~0.31
in. (2~8 mm) less than rear dis-
tance. if not, adjust ball joint length.
CS2510,2610-유럽,호주향-07.indd 29
READJUsTMENT
t46OA36A
(1) tie rod lock nut
1. loosen the lock nut and turn the
turnbuckle to adjust the rod length
until the proper toe-in measure-
ment is obtained.
2. check the toe-in value after the tie
rod is adjusted.
3. adjust it again if necessary.
ChECkING RADIATOR hOsE AND
ClAMP (z)
M46O730A
(2) tie rod (1) clamp
check to ensure the radiator hoses
are free from damage and are tight-
ened properly every 200 hours or ev-
ery 6 months, whichever comes first.
1. if the hose clamps are loose or
water leaks from hose, tighten
clamps securely.
2. if the radiator hoses are swollen,
hardened, cracked, or otherwise
damaged, you must replace the
hoses. failure to do so could lead
to coolant loss and engine damage.
7
- 
maintenance
M46O731A
(2) hose
7
2020-11-10 오전 9:08:13