Using Tractor After Storage - Kioti CS2510H Operation Instructions Manual

12. if a loader or implement is in-
stalled, lower it onto level ground.
13. apply grease to the exposed cyl-
inder rod.
14. Wash the cooling system and
drain water from it. also, add
anti-freeze.
15. Replace all the oil and filters.
16. Replace the air cleaner filter.
17. Chock the frame in order to re-
move the weight from the tires.
18. set all control systems to neutral
position.
19. Plug any open exhaust pipes.
20. attach a tag onto the tractor to
inform the storage condition of
the tractor.
CS2510,2610-유럽,호주향-08.indd 3
CAUTION
To avoid injury:
never clean the tractor body

while the engine is running.
never run the engine in an en-

closed area without proper venti-
lation system in order to prevent
poisoning by exhaust gas.
When storing the tractor, re-

move the key from the switch
and store it separately in order
to prevent an unauthorized per-
son from operating the tractor
and being injured.
cover the tractor after the muf-

fler and the engine have cooled
down.
if the battery is not to be removed,

disconnect its negative termi-
nal. The wiring can be gnawed
by rodents, leading to a fire.
storage anD DisPosal
Using TracTor afTer
sTorage
1. Check the tire air pressure and in-
flate the tires if they are low.
2. install a fully charged battery.
3. Check the fan belt tension.
4. Check all fluid levels. (Engine oil,
transmission/hydraulic oil, engine
coolant and any attached imple-
ments)
5. remove grease from the exposed
cylinder rod.
6. apply grease to the lubrication
points.
7.get onto the tractor and start the
engine.
8. Check if the instrument panel and
all parts operate correctly while
running the engine for a few min-
utes.
9. Drive the tractor outside and check
if it is operating properly. Park the
tractor outside and idle engine for at
least 5 minutes. stop the engine and
visually inspect the tractor. Check if
there is leakage.
8
- 
8
2020-04-03 오전 9:44:39