Kioti CS2510H Operation Instructions Manual page 171

(1) turn signal lamp Bulb
3. with the bulb pressed downward,
turn it counterclockwise to remove
it. replace it with a new one.
CS2510,2610-유럽,호주향-07.indd 39
CAUTION
Do not touch the bulb if it is

still illuminated or right after
it is turned "Off". you can be
burned by the hot bulb.
for some bulbs which require

delicate handling or work pro-
cess, contact your local kIOTI
Dealer.
Do not touch the illuminating
tb2O715A

glass part of the halogen bulb.
The bulb life can be shortened
by finger prints, dust and mois-
ture, or the bulb even can be
broken. Clean it with soft cloth.
The halogen bulb contains

compressed gas, so it can ex-
plode if dropping or scratching
it. Therefore, never use a bulb if
it is scratched or was dropped.
maintenance
CAUTION
When separating the cover by

prying it "Off" with a screw-
driver, be careful not to dam-
age it.
Before replacing a bulb, make

sure to put the key switch and
the switch for the correspond-
ing bulb to the "Off" position.
Install a new bulb with the

same capacity after removing
the installed bulb.
2020-11-10 오전 9:08:20
7
- 
7