Nakayama MB9005 Manual page 38

position
Failure to shift the reversing
shift to the right position
The reversing gears do not
reset
The reversing shaft is loose
Too much noise from the
gears
Oil leakage of the main
shaft's rear cover
Oil leakage of the reversing
shaft
Oil leakage of the fork shaft
of the reversing shaft
Oil leakage of the fork shaft
of the clutch
Oil leakage of the shift shaft
Oil leakage of the flange
connection
Leakage of the gear-box
body
18
WWW
Driving angle gear is loose
Excess abrasion of the upper hole in the
connection piece of support arm
Positioning spring inside the main shaft does
not function
Main shaft is moving ,the bolts for tightening
the cover for the rear of the gear-box body are
loose
Deformation of shift bar brings about
interference when you shift
Abrasion of reversing fork
Malfunction of reversing cable
the reversing shaft is loose
The reversing fork is blocked to a standstill
The loosening of reversing shaft makes the
gear be blocked to a standstill
Malfunction of spring of the reversing shaft
The reversing shaft is bent and deformed
Rear bolts of reversing shaft are loose
The matching between reversing shaft and
gear-box body is too loose
Deformation and bend of the angle gear and
reversing shaft
Too much lateral clearance due to excess
abrasion of gears
The matching between bevel gear and
reversing shaft and gear-box body is too
loose
Malfunction of O-shaped ring for the main
shaft
Malfunction of lip-shaped oil seal in the main
shaft
Malfunction of O-shaped ring for the cover
Loosening of bolts at the back of reversing
shaft
Malfunction of O-shaped ring of the
reversing shaft
Malfunction of O-shaped ring
Malfunction of O-shaped ring
Malfunction of O-shaped ring
The bolts are loose there
The vulcanized paper board is damaged there Replace
The gear-box body has tiny hidden holes
.N
AKAYAMA
Tighten the round nuts
Replace the support arm assembly
Replace
Screw the bolts tight
Adjust the shift bar or Replace it
Re-adjust the cable of reversing shift
Replace the reversing fork
Re-adjust the cable
Replace the cable
Screw the bolts tight at the back of the
reversing shaft
Clean the combined face between
reversing fork and reversing pushing
plate to make the fork move freely
Screw the bolts tight at the back of the
reversing shaft.
Replace the spring
Replace the reversing shaft
Screw the reversing shaft
Replace
Replace
Replace the gears
Replace
Replace with O-shaped ring ∮17×1.8
Replace with lip-shaped oil seal B25407
Replace with O-shaped ring ∮46×1.8
Screw the bolts tight
Replace with O-shaped ring ∮18×1.8
Replace with O-shaped ring ∮1.2×1.8
Replace with O-shaped ring ∮1.2×1.8
Replace with O-shaped ring ∮1.2×1.8
Screw the bolts tight
Re-welding or brush base paint to stop
the leaking
T .
OOLS COM