Nakayama MB9005 Manual page 36

piece of the clutch can be confirmed. The machine should be sent to special service
centre for replacing with a new fork of friction piece of the clutch.
3. Dismount the clutch by unspecialized person, which may cause damage to the clutch
and the machine is forbidden.
Ⅳ. Debugging Method of Accelerator Cables
When spinning the throttle switch, acceleration or deceleration performance if the
diesel engine is not good, adjust the throttle switch. Refer to Chapter Three for measures.
Note: 1. Repeatedly spin the throttle switch for 2-3 times and confirm whether the
acceleration or deceleration performance of the diesel engine is ok.
2. Joint of the cable must be firmly connected to the throttle cable.
Ⅴ.Use & Debugging Method of Handle bar Frame
According to your height, farming and other special requirements ,the handle bar
connection can be adjusted up and down, left and right appropriately, measure are
interpreted as following: (see figure 12)
1. The up and down debugging for the handle bar connection
① Unscrew the Locked handle of the handle bar connection, and make the terminal
tooth between the handle bar connection and the handle bar base separated.
② Select the best position for the handle bar connection according to your height and
likes.
③ Then spin the handle to make the terminal teeth between the handle bar connection
and handle bar base engage well with each other.
2. The left and right debugging for the handle bar connection.
① Unscrew the locknut handle of the handle bar base and the upper and lower terminal
teeth.
② Spin the handle bar left or right to the desired position.
③ Then screw the locknut handle to make the higher and lower terminal teeth of the
handle bar base engage well with each other.
16
WWW
.N
AKAYAMA
T .
OOLS COM