Nakayama MB9005 Manual page 23

the fork arm of the clutch, and put the joint of cable into the wire socket.
⑤ Unscrew the tie rod, grasp and loosen the clutch handle until the spring force
in the clutch can reset the handle, then screw the locknut.
2. Adjustment of the reversing gear cable(See Figure 5 and 6)
① Unscrew the locknut of the tie rod.
② Spin the tie rod clockwise until the bare handle support is the shortest.
③ Get the cable into the reversing fork shaft besides the gear-box, and ensure
the joint of cable goes into the hole of the fork shaft.
④ Properly pull the reversing fork shaft counterclockwise, get the cable into the
narrow gap of the reversing wire socket besides the gear-box, and ensure the
pipe head goes into the hole of the wire socket.
⑤ Unscrew the tie rod, grasp and loosen the clutch handle until the spring force
in the clutch can reset the handle, then screw the locknut.
3. Adjustment of the throttle cable (See Figure 7)
① shift the throttle switch clockwise to minimum positioning.
② Get wire of the throttle cable into the threading base and firm base on
top of the throttle adjustment board of the diesel engine.
③ Tighten the wire, screw the binding bolts on the firm base.
④ Adjust the throttle switch repeatedly until the throttle handle on the oil valve
adjustment board can reach the maximum and minimum position.
4. Detailed information for the installation and adjustment of cable, refer to the
disk attached.
3
WWW
.N
AKAYAMA
T .
OOLS COM