Preparations For Mounting; Assembly Procedure - Siemens VersiCharge 8EM1310-F.0 Series Operating Instructions Manual

4.2

Preparations for mounting

Requirements
• Follow the national legal requirements for the mounting and electrical installation.
• Installation site:
– The wall is even and load-bearing
– When mounting on a column or anywhere else, observe the applicable installation and
• Connection to the power supply is ready.
• All power supply connections are de-energized and secured against unintentional
reconnection.
Required tools
The required tools are not included in the scope of delivery.
• SW 36 open-ended wrench
• Optional cable gland
• Phillips head screwdriver set
• Slotted screwdriver set
• Torx TR screwdriver set
• Tool set for electricians
• Spirit level
• If applicable, crimping tool and installation tool for RJ45 plug
Tools for stone wall or concrete wall:
• Impact drill
• Masonry drill ∅ 8 mm
• Hammer
4.3

Assembly procedure

Specific safety measures
Risk of electric shock when moist due to condensed water
Before commissioning the Wallbox, an authorized and qualified electrician must check
whether there is moisture in the Wallbox. Remove even small amounts of condensed water
before commissioning. Take appropriate measures for drying.
Do not switch off the power supply for an extended period of time after commissioning. This
prevents condensation in the Wallbox. If the Wallbox is to be switched off for a longer period
of time, you need to provide suitable moisture protection.
VersiCharge AC Wallbox Operating Instructions ERK
Operating Instructions, 08/2023, A5E51549696-AC
mounting information.
DANGER
Mounting / Installing / Connecting
4.3 Assembly procedure
29