11.36
Checking the chain, rear sprocket, engine sprocket, and chain guide
Info
The wide adjustment range of the chain adjusters (32 mm
(1.26 in)) enables different secondary ratios with the same
chain length.
Chain adjusters
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Shift the transmission into neutral.
–
Check the chain, rear sprocket, and engine sprocket for wear.
»
If the chain, rear sprocket or engine sprocket is worn:
–
Change the drivetrain kit.
400227-01
–
Pull on the top section of the chain with the specified weight
Guideline
Weight, chain wear measure-
ment
–
Measure distance
Info
Chain wear is not always even, so you should repeat this
measurement at different chain positions.
Maximum distance
18 chain rollers at the longest
chain section
»
B
If distance
–
Change the drivetrain kit.
400987-10
SERVICE WORK ON THE CHASSIS 11
4
can be turned by 180°.
p. 41)
Info
The engine sprocket, rear sprocket, and chain
should always be replaced together.
10 ... 15 kg (22 ... 33 lb.)
B
of 18 chain rollers in the lower chain section.
219 mm (8.62 in)
B
from
is greater than the specified measurement:
Info
When a new chain is mounted, the rear sprocket
and engine sprocket should also be changed.
New chains wear out faster on an old, worn rear
sprocket or engine sprocket.
p. 41)
A
.
61