Conair W Series User Manual page 66

4 - 3 0 l O p e r a t i o n
C o n t r o l F u n c t i o n D e s c r i p t i o n s
S c r e e n
SCREEN 81 Communications
PROTOCOL
DEVICENET
SCREEN 82 Communications
SLAVE ID
1
SCREEN 83 Communications
BAUD RATE
9600
SCREEN 84 Communications
PARITY
NONE
F u n c t i o n
This screen shows the communications
protocol. Modbus, DeviceNet, Ethernet or
SPI are available. This is set at the facto-
EDIT
ry. If adding to an existing dryer, the com-
munications protocol can be changed with
the proper password (see page 4-31, screen
85).
This screen shows the Slave ID number.
The ID number can be changed with the
proper password (see page 4-31, screen
EDIT
85) by pressing the Select Category button
below the word Edit and entering a value
on the keypad or scrolling to the desired
value using the Adjust Setpoint keys. The
"ENTER" key needs to be pressed to lock
in the new number.
This screen shows the baud rate. The
baud rate can be changed with the proper
password (see page 4-31, screen 85). Press
EDIT
the Select Category key below the word
Edit and enter a value on the keypad or
scroll to the desired value using the Adjust
Setpoint keys.
This screen shows the parity. The parity
can be changed with the proper password
(see page 4-31, screen 85) to Even, Odd,
EDIT or None by pressing the Select Category
button below the word Edit. The
"ENTER" key needs to be pressed to
lock in the new number.
( c o n t i n u e d )