Using The Ethernet Parameter List - Conair W Series User Manual

I n s t a l l i n g t h e E t h e r n e t
C o m m u n i c a t i o n H a r d w a r e
4
Once you have entered the correct value, scroll down one more time until
"IP Addr Part 2" is displayed. This is the second octet (first three numbers) of
the IP address and may be changed if necessary.
5
Scrolling further down you will see additional fields for the remaining IP
address octets, the subnet mask and the gateway. Once all fields have been
changed, cycling the power to the dryer will complete the process and reinitial-
ize the Ethernet interface.
U s i n g t h e E t h e r n e t Pa r a m e t e r L i s t
Please refer to page Appendix A page A-4 for a list of the parameters that are
available with the Modbus TCP/IP interface.
CAUTION: Writing to a location with improper data, or writing to an incorrect loca-
tion outside of the specified range may cause your common controls system to
become inoperative or to operate in a manner that may damage your process. Be
certain that you understand each parameter and its effect before changing any-
thing. Conair recommends that you initially attempt to read from the registers and
do not complete any writes. Once the information you are trying to read has been
confirmed as accurate, you can now program in your new or additional data.
i
NOTE: The list of parameters that may be read and written to via Modbus TCP/IP is
extensive. Some of these parameters are naturally a part of the operation of the
machine and others may be obscure configuration settings. The parameter list in
Appendix A page A-4 includes a column with a recommendation as to whether the
parameter should be accessed by a user program. Addresses that are not consecutive
indicate that there are other parameters present which are not recommended for usage
by the user.
( c o n t i n u e d )
E t h e r n e t C o m m u n i c a t i o n s l B - 3