Checking For Proper Air Flow; C H E C K I N G F O R P R O P E R A I R F L O W - Conair W Series User Manual

Carousel plus dryer

Table of Contents

This procedure is required on W 50 - 100 models if the phase detection option was

not ordered with the dryer.

IMPORTANT: This procedure must be performed before the dryer's air hoses are

connected to the hopper or before loading material into the hopper.

CAUTION: If the air flow direction is incorrect due to improper phase connection,

material from the hopper can be pulled into the process heater, causing permanent

damage to this equipment.

Turn on the main power to the dryer. Make sure the dryer's disconnect dial is

in the "ON" position. This powers up the control and the display lights will

illuminate.

Select the setpoint temperature by pressing the select category button

under the setpoint temperature display. Once selected, the number will

flash.

Set the drying temperature. Press the select category button under the set-

point value until it blinks then use the setpoint adjustment (+) or (-) buttons or

enter a low setpoint temperature (150ºF {66ºC}) on the numeric keypad and

then press enter.

Select

Chapters

Table of Contents

W 15 W 25 W 50 W 75 W 100