Lines At Swath Boundary - Canon Colorado M Series Operation Manual

Lines at swath boundary

Introduction
Swath boundary. Two adjoining swaths/passes of the printhead must be positioned without
overlap (dark lines), or gap (white lines).
Problem description
OD lines occur at the
swath boundary.
OD of the lines usually
varies over the print
(from left to right or
from line to line).
Very sharp line(s), no
OD variation over
print and only for a
single mono-color
(and its corresponding
mixed colors).
For some (fast) print
mode and print medi-
um combinations,
gloss/OD swath boun-
dary lines will always
be present.
Follow the procedure below. You can stop at any time in the procedure when the problem is
solved.
Usually worse during
st
1 meter.
Independent from pa-
per step errors,
though paper step op-
timization may reduce
visibility.
Cause
This is caused by a
nozzle failure at swath
boundary and not due
to paper step.
Roll core gear is dam-
aged or warn out. Or-
der new and replace.
Chapter 9 - Troubleshooting and support
Lines at swath boundary
Action
Perform a media cali-
bration.
Run automatic main-
tenance + nozzle opti-
mization.
Start automatic
See
maintenance on
page 180.
Manual optimization
of the paper step cor-
rection may reduce
Change
visibility, see
the media settings on
page 76.
Switch to a slower
Select
print mode see
a print mode on
page 84.
335