White ink in the RIP
PDF file settings for Onyx
In order to verify if the PDF file is prepared correctly, you need to check the output and format
settings.
1. Open the PDF file in Job Editor.
2. Select the correct media profile and print mode.
When the file has been made up for White ink:
• [Output] should equal [CMYK + 2 spots].
• [Format] in the [Source Image] section should equal [CMYK + 2 spots].
3. To check that the White part will be printed, hover the mouse over an area in the image that
should be printed in White. Check at the bottom of the Job Editor whether there is a CMYK
72
Chapter 4 - Handle the media